traktory



Question #1:

are john deere riding mowers worth the money?

I have two cub cadets... an International Harvester that is at 700+ hours and still works fine (usually) and a cheap MTD cub cadet bought about 7 years ago that surprisingly lasted over 500 hours but now cuts like crap and is literally falling apart. I want to purchase a nice riding mower (not a z-turn) good for over 6 acres a week that will last for a long time and will maintain its nice cutting ability for a while. I'm thinking the John Deere 304x will do great, but is it really what its worked up to be? Or is there a cheaper option that is equally as well-built?

Thanks!

Question #2:

Who makes the transmission for the js20 john deere self propelled mower part #GX22289?

Click Here

Question #3:

2-stroke weedwacker tuning?

i have a john deere S1400 30cc weedwhacker. it bogs cold or hot after 50% throttle and stays bogging till you bring it down. i'm going to clean the carb and filter and put fresh gas in it. but would like help anyways. thanks ahead of time
the spark plug is also very black
i replaced the primer bulb cause it was all crack and leaking gas. but didnt try it with the new one in before i cleaned it all up. its too late to start a weedwhacker tonight. maybe it was just the primer i dont know now cause ive done the other stuff to it.

Question #4:

Why did John Deere make yellow tractors for a little while?



Question #5:

John Deere M 3 point conversion?

I want to convert my john deere m with a 3 point hitch. I have some questions about the one I am looking at.
Click Here
Would this fit all imploments (blade, brush hog, ect.)

Question #6:

disable rio switch am124734 on john deere riding mower sx85?



Question #7:

What do you call a part that I am looking for on my john deere L130?

It is a Pin or Clip I guess is what you call it, that basically goes into hots to secure mower deck. It looks like a hair pin ... ahhh do not know the name of it. I need tons of these (hoping to find them on eBay), please give me a correct name so I can find them there (eBay)?

Click Here

Question #8:

where do i find a belt diagram online?

does anyone know where to find a diagram online that shows the route for the deck belt on a model LA175 john deere mower

Question #9:

how can i disengage the eletric pto on a john deere 145 when the switch is in the off position?

the engine tries to start with the switch off but it does not have enough to turn the engine and the pto. when i pull the switch nothing happens so i know the switch is working but the clutch will not disengage.

Question #10:

John Deere blowing oil through air cleaner?

has kawasaki engine

Question #11:

What do you think of a girl who drive a VW Slug bug?

A green one, with SF giants & john deere deere decals.
And with daisy break light covers.
With a Crankbait hanging from the rearview mirror?
haha, thanks:)

Question #12:

What do you think of a girl that drives a slug bug?

A green one, with SF giants & john deere deere decals.
And with daisy break light covers.
With a Crankbait hanging from the rearview mirror?
haha, thanks:)

Question #13:

I made up invites for my sons bday but forgot to add that I need people to bring a side-dish. How do I ask?

My son is turning three and I made up really cute invites. After I printed them up my hubby and I decided that we were going to do hamburgers and hot dogs, but because of a money crunch we wanted to ask every one to bring a side-dish. How should I word it for a John Deere/Farm themed bday party?
It is all family and our close friends coming to the party and I can call all of them up and ask them to bring something without them batting an eye because thats just how we do parties, but thought i could get some help with cute wording to ask them along with the cute invites. I'm not asking if its ok to ask,or asking my friends to foot the bill for my sons party, so please don't answer if your going to lecture me one ediquet! I just wanted cute wording!

Question #14:

HELP! Anyone with model of the John Deere Sabre that's single cylinder and hydrostatic drive?

I need a somewhat small favor asap. i was disassembling the carburetor and accidentally disconnected the throttle/choke linkages and i cannot find any way to reconnect the throttle linkage. If you have this mower could you please please please do me the favor of taking a picture of i for me so i can see where its connected. It's not at all hard to get to, you just have to remove the air filter assembly which goes back on no problem. i really need help with this and help would be so greatly cherished. I've looked all over for directions and diagrams for the Sabre but cannot find directions of actually where he throttle linkage goes and how to install it. I haven't mowed the lawn in over week and I'm growing a jungle around my house
i have all the diagrams i need thank you for recommending the briggs site. embarrassing i never thought of that before. but sadly i still am left with no instructions of how the throttle linkages are installed or what it looks like when it is installed

Question #15:

Wedding ideas for a john deere themed wedding?

I am getting married in febuary of 2011 and am planning a john deere themed wedding. I need ideas for everything :) I have looked on the internet but want some more input. Bridesmaid dresses, flowers, decorations, centerpieces, ect. Links with pictures would be greatly appreciated :) Any ideas or advice would be greatly appreciated. Thanks

Question #16:

where can i get a john deere trucker hat?

i have no idea why but i have been OBSESSSING over getting one! i have no idea where to get one. i heard they're at gas stations but which ones? im not willing to pay more than $20 for one. please help me out here :)

something close to this ---> Click Here

Question #17:

Any one know were i can get a quilt pattern?

i want to make a quilt that has jean squares and some john deere squares too>

Question #18:

John Deere 345 tractor, engine races when not under load.?

When mowing or tilling everything is fine but once I turn off implement the engine races and I have to throttle it down to compensate fearing engine damage. Where should I be looking to solve this problem?

Question #19:

john deere mowers, are they good investment?

what is your opinion which model should I get, have you had good luck with them?

Question #20:

How fast would a riding lawn mower go without it's governor (it's a 17.5 HP engine)?

Besides all the damage I did (i.e.cutting off the drive belt, disassembling the Foward,Neutral,Reverse lever, disassembling the speed selector (park, 7-speed)) how fast could I expect my mower to go as a GoKart?
Would you recommend me trying taking the governor off my 2 year old John Deere riding mower to test the idea?
What I was working on before and was a better idea was an MTD ~ 10 years old.

* 33 minutes ago
* - 4 days left to answer.

Additional Details
I'm not so sure "In general" that this project would have worked anyway. I had my doubts. My initial idea was to strip everything down to the driveshaft/engine (basically take the frame away). Then I looked at the mower and IT looked like a good GoKart frame. However, now I think that it is not as safe and well designed as taking the engine and putting it on something else if it goes really really fast.
No, I agree with yah Ken. I can see that you followed my double post lol.
All good. I already put everything away





** Powered by Yahoo Answers